BeyondTrust Appliance B Series Installation
For installation instructions, please refer to the flyout instructions included with your BeyondTrust Appliance B Series.
Power On the BeyondTrust Appliance B Series
- Plug the power cables for the B Series Appliance into a safe power source. Depending on the type of B Series Appliance, you may have two power cables. The B Series Appliance’s power supplies will automatically switch between 120v and 240v, as needed.
- Using one of the patch cables provided, connect your computer to NIC1 or NIC2 on the rear of the B Series Appliance. If using DHCP, plug the provided straight-through cable into the network directly, and the B Series Appliance automatically receives a new IP address.
BeyondTrust supports placing both NICs on the same network for the purpose of NIC Teaming. Likewise, NICs can be placed on separate network subnets for segmented traffic routing. However, if placing NICs on the same network for the purpose of NIC Teaming, configure only one of the NICs. If both NICs have IP addresses from the same subnet, unexpected behavior will result. When multiple IP addresses are required for a single subnet, the proper solution is to assign all the IP address to one NIC.
- Press and release the power button on the front of the B Series Appliance. The power LED immediately to the right of the reset button will illuminate, and the HDD activity LED (immediately to the right of the power LED) will begin to flash. Initialization of the B Series Appliance will complete in about 60 seconds.
The NIC1 and NIC2 LEDs may illuminate and show activity even when the B Series Appliance is not powered on; therefore, it is important to check the power and HDD LEDs to confirm that the B Series Appliance is on.